Label stock
Review the face stock, adhesive, liner and finishing sequence as one roll-to-roll application.
Explore →Short-Run Label Finishing
Evaluate frequent job changes, registration and accepted roll output when comparing digital label finishing workflows.
Production challenge
Short-run label production can be constrained by setup and finishing even when printing is fast. Design changes, stock changes and matrix removal need to be evaluated together.
Materials in the workflow
Required operations
Review lamination, digitally controlled cutting, slitting, waste removal and rewind. The RK2 catalog describes an integrated roll-to-roll process; laser selection needs a stock-specific compatibility review.
From job file to finished parts
- Define the stockRecord face stock, adhesive, liner, width and any applied laminate.
- Use real jobsSelect several shapes and repeat lengths, including the difficult corners and dense layouts.
- Run complete finishingInspect liner integrity, matrix removal, slit widths and rewind quality.
- Compare accepted outputCount finished rolls and setup waste instead of quoting motion speed alone.
Systems to discuss
IECHO RK2
Roll-to-roll digital self-adhesive material system integrating lamination, cutting, slitting, winding and waste discharge.
View system →IECHO LCT2
Laser finishing system with manufacturer-described web tension control, correction and smoke removal systems.
View system →Questions before selecting equipment
- Typical order and version mix
- Registration and dispensing requirements
- Matrix stripping reliability
- Knife versus laser material suitability
Frequently asked questions
Does die-less finishing eliminate all setup?
No. Files, registration, material settings and downstream handling still need setup. The absence of a physical cutting die does not remove those production steps.
Manufacturer references
- IECHO RK2 — manufacturer catalog, exported October 4, 2026
- IECHO LCT2 — manufacturer catalog, exported October 4, 2026